Tuesday, May 3, 2011

... in which I reveal my army board, and give my first painting update. (WARNING*** LOTS**** of pictures)

 First, I'll let the pictures speak for themselves.


 Tombworld deployment. Above is my 1850 army I would like to run on June 4th.




Here's how I did it, start to finish:

I started with a piece of regular foam board. Now, I wanted to magnetize the board so the minis would be secure, but not glue a ton of magnets to the board. I wanted to be able to use the board for multiple versions of my Necron army, not just this incarnation. So, after a quick trip to the local hardware store, I picked up a piece of steel duct panel. Be careful, this stuff is sharp on the edges. Trust me, you only make the mistake of handling this stuff without gloves ONCE. It was only $4 for a 20"x30" sheet.

I tested the paint and the flock, to make sure the magnet would hold thru the multiple layers.

Pretty successful, don't you think? Worked like a charm.

After using rubber cement to glue the metal to the foam board, I masked off the edges of the panel so that the metal would not be exposed.
Afterwards, a quick coat of black primer.





Next, I began working on the mountain. While the mountain was drying, I would switch off to flocking the board. This step took forever... Not much work for a lot of results, but a lot of time waiting for glue to dry.
I started with some spare foam I had laying around. It is actually the foam that gets pulled out from army trays. I just used Elmer's glue, Popsicle sticks and some brass rods to hold the foam in place while it dried.

Next, I used some plaster cloth to cover the foam form. You can pick up plaster cloth at your local craft store. After about a half an hour, I was able to mix up some more plaster to fill in the gaps and flesh out the base. Here's where I had to switch gears because it had to dry over night.

Next, a layer of black primer.

I took my Dremmel and cut the Necron symbol into the rock face. Drybrush a layer of rust colored red, and then a heavy coat of black ink. Here's the result.

Back to the board. I cut up some of the leftover gauss rod sprues, and chopped up the pieces that didn't look like crystals. I glued the chopped up pieces on like patches of rocks, and made little outcroppings of the squarish rods like crystal formations. I also used some clear casting resin and some rock molds to cast the large green clear rocks.

Here's the first coat of flock. I used rust colored ballast to simulate the rocky "martian" like landscape. I glue things on in patches like this for a good reason. I use a mixture of 1/2 water and 1/2 elmer's glue to hold the flock. When I let a section dry, and then go back over the edge of it at a later time, it gives a second layer and a "windswept" appearance.







Now you can see the landscape coming together.









My son, Finn






As for all the mess of the flock, I employ slave labor to clean up my mess behind me.

Some glue under the mountain, some flock around the base, and some clear green rocks and some Necron rods on the mountain.

I decided to make a frame for the board. All I did was pick up moulding from the hardware store, cut it at 45 degree angles, glue, clamp and nail it together. If someone requests it, I'll go into more detail about the frame another time.

After painting the frame black, but before I gloss coated it, I decided to put some Necron glyph decals on around the boarder of the frame.

One complete army board.
Now for the painting update....

3 down! Yes, I am aware that is not quite the 21 I should have done by now, but finals are this week... priorities and all. I do however, have 14 with paint on them very close to completion, and 12 more built and primed today. I would have done more, but I ran out of primer.... again. So, 3 down, 203 to go, and a chuck of about 20 that will be done shortly.

Now I bid you all goodnight, it is after midnight, so please excuse my posting if it is erratic... I'll edit and clean it up later.. sleep now...

1 comment:

  1. So sweet of Finn to help you clean out the army foam board mess. It's great that you got him exposed to arts - and slavery :) - at a young age.

    ReplyDelete